Display Cycle Count; Operation - Drucker Diagnostics HORIZON SERIE Manual Del Operador

Naming the Cycle
Programming Mode
D C C
ISPLAY YCLE OUNT
These actions will display the cycle count.
Enter Settings
Navigate to Cycle
Exit Settings Mode
O
PERATION
o Place the tubes into the tube holders. Be sure to follow the rules for balanced loads as listed in the next section.
o Close the lid and turn the lid knob clockwise to its complete stop position.
o The digital screen shows the currently selected cycle. To select another cycle, press the UP or DOWN button in
succession until the desired cycle is selected.
o Pushing the START button on the control panel will start the spin cycle.
o When the cycle is completed, the rotor will slow to a complete stop and the lid light will flash.
o The unlocking mechanism will engage for 60 seconds allowing entry into the rotor chamber. To unlock after more
than 60 seconds have elapsed, press the UNLOCK button. The lid will unlock for another 15 seconds.
o Turn the lid knob counterclockwise and open the lid. The lid light will turn off.
Navigate to the cycle name with the left and right arrow. Change
the blinking character of the name with the up and down buttons,
then move to the next character with the right arrow. Repeat.
Save and Exit Press the GEAR button. The cycle displayed on the screen will be
automatically saved.
Press the GEAR button.
Mode
Press the left arrow once to access the cycle counter
Counter
Press the GEAR button.
| 6