Mounting The Loudspeaker - Bose Professional DesignMax DM2C-LP Serie Manual De Instrucciones

PRO.BOSE.COM
Preparing Hard Ceiling (Existing Construction)
Cutting the Ceiling
1. Use the template to trace a hole onto
the ceiling.
2. Cut a hole into the ceiling.
Installing the Tile Bridge
1. Insert the tile bridge rails and ring
through the hole and place the rails
parallel to each other across the
ceiling grid or ceiling furring.
2. Assemble the tile bridge.

Mounting the Loudspeaker

1. Pass the audio wire through the wire opening.
2. Insert the loudspeaker through the hole and into the tile bridge. Make sure the anchors engage on the tile bridge
before loosening your grip on the loudspeaker.
3. Remove the connector, wire the connector, and reinsert the connector into the loudspeaker. For wiring information, see
Wiring the Loudspeaker on page 5.
4. Tighten the anchor arm screws to secure the loudspeaker. If using a power drill, set to a low torque setting.
WARNING: Over-tightening the screws may result in damage to the anchor attachment point or the ceiling,
which could lead to a falling hazard.
q
e
Installation Guide • DesignMax DM2C-LP
q
q
w
r
w
w
Installation
English • 7