Specifications - RIDGID MegaPress Manual Del Operador

a. HC-75-G Drill Guide
1 – Guide Tube
2 – Vacuum Connection
3 – Adjusting Nut
4 – Chain
5 – Alignment Mark
6 – Orientation Slot
c. HC-75-E Expander
1 – Body
2 – Draw Bolt
Figure 1 – RIDGID MegaPress Press-In Branch Connector Installation Kit

Specifications

Guide/Arbor Shaft Assembly
For use with pipe sizes ....1¼" (32mm)
Hole size cut ....................27mm (RIDGID
Pilot Drill Size ..................¼" (RIDGID
Hex Shaft Connection......¼" Hex
Vacuum Connection ........1¼" (32 mm)
059-100-256.10_REV. A
MegaPress ® Press-In Branch Connector Installation Kit
1 1 / " (40mm)
2
2" (50mm)
3" (75mm)
4" (100mm)
6" (150mm)
Cat# 52795 Hole
Saw)
Cat# 53085)
b. HC-75-A Arbor Shaft Assembly
1 – Hex shaft
2 – RIDGID M27 (27 mm) Hole Saw
3 – Pilot Drill
4 – Guide Carriage
5 – Orientation Pin
d. Fitting Positioning Guides
(Available for 1 1 / " to 6" pipe sizes, see mark-
4
ings)
1 – Handle
2 – Connector Holder
Weight (Drill Guide) .........6.5 lbs
Weight (Arbor Shaft) ........1.4 lbs
MegaPress Expander
Press Tools used with...........RIDGID Standard
Weight .............................1.5 lbs
Fitting Positioning Guides
1¼" Pipe ..........................0.4 lbs
1 / " Pipe ..........................0.4 lbs
1
2
2" Pipe .............................0.5 lbs
3" Pipe .............................0.7 lbs
4" Pipe .............................1 lbs
6" Pipe .............................1.4 lbs
(32 kN) (Such as
RP 340, RP 330,
RP-320E, CT 400)
5