Advanced Settings - Fisher&Paykel myAIRVO 2 Manual De Usuario

ADVANCED SETTINGS

When you see the "Warm-up" or "Ready for use" symbols, you can
press the Mode button to view and change advanced settings.
TARGET DEW-POINT TEMPERATURE
You can set the myAIRVO 2 to three target dew-point temperature
settings:
• 37°C (98.6°F)
• 34°C (93°F) [if compliance at 37°C is a problem]
• 31°C (88°F) [for face masks only].
You may not have access to all settings, if:
• the unit is in Junior Mode (limited to 34 °C),
• the unit was initially set up with tighter limits.
The myAIRVO 2 will remember its target dew-point temperature setting
when you switch it off.
Press the Mode button to move on to the next screen.
TARGET FLOW
You can set the myAIRVO 2 to flows between 10 L/min and 60 L/min, in
increments of 1 L/min (10-25 L/min) and 5 L/min (25-60 L/min).
You may not have access to all settings, if:
• the unit is in Junior Mode (limited to 2 - 25 L/min, in increments of
1 L/min)
• the unit was initially set up with tighter limits.
The myAIRVO 2 will remember its target flow setting when you switch
it off.
At altitude, the maximum flow rates achievable may be lower than those
listed above, by 5 L/min per 1000 m (3000 ft).
Press the Mode button to move on to the next screen.
A – 8
To change the target dew-point temperature
setting:
Press the Up and Down buttons to choose the new
setting.
The large number in the center of the screen shows
your chosen setting.
The small numbers near the arrow show the minimum
and maximum accessible settings.
To change the target flow setting:
Press the Up and Down buttons to choose the new
setting.
The large number in the center of the screen shows
your chosen setting.
The small numbers near the arrow show the minimum
and maximum accessible settings.