Visual Check - Bond BHDIY-003 Manual De Usuario

VISUAL CHECK

Prior to each use, check the hose and valve for excessive wear, abrasions or any
damage.
LEAK TESTTTTTTTTTTTTTTTTTTTTTTTTTTT
L
K TES
1.Perform a leak test in a well-ventilated area outside.
2.Make sure any open flames or cigarettes are extinguished.
3.Remove the battery.
4.Ensure the burner control knob is in the "OFF" position.
5.In a bowl, create a soap solution using 1 part water and 1 part liquid detergent.
6.Apply the soapy water solution to all connections.
7.Open LP tank valve.
8.A gas leak will be detected by expanding bubbles originating from the point of the leak.
9.If a leak is found at any connection point or if you smell gas, close the tank valve,
disconnect the tank and do not use the appliance until repairs can be made.
TO LIGHT
TIPS: Before Beginning ●Read and understand the instructions thoroughly.
1. Locate the burner control knob and make sure it is in
the "OFF" position.
2. Connect propane (LP) cylinder. (See above pages).
3. Open LP tank valve slowly.
4. Push in igniter button to create sparks at the electrode and hold.
5. Push and turn burner control knob
counterclockwise to the "PILOT" position. Continue
to push the control to light the pilot flame.
Note: For initial start or after any cylinder
change, hold Control Knob IN for 2 minutes to
purge air from gas lines before proceeding.
6. After ignition, release the igniter button. Continue
to push the control knob for 45 seconds.
7. If ignition does NOT immediately take place on pilot
burner in seconds, turn the burner control knob to
"OFF", wait 5 minutes for gas to clear and repeat the
lighting procedure. If pilot still will
not light, refer to the Troubleshooting Section.
●Check and make sure that all parts are present.
●For future reference, save this instruction sheet.
10