Bond BHDIY-003 Manual De Usuario página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8. Once the pilot is lit, turn the burner control knob to
"High" and "Low" positions. Main burner will light
immediately. If not, turn the burner control knob to
"OFF", wait 5 minutes for gas to clear and repeat the
lighting procedure. If main burner still will not light,refer
to the Troubleshooting Section.
9. Flame height can be changed by adjusting
the burner control knob between the "High"
and "Low" positions.
10.Always check burner and pilot flames
periodically to ensure proper operation.
Flames should be mostly yellow with some
blue for best performance. (See diagrams)
If the burner does not ignite with the burner control valve open, gas will continue
to flow out of the burner and could accidentally ignite causing injury or property
damage.
USING A LONG MATCH OR LIGHTER
1. Connect propane (LP) cylinder (See above pages).
2. Before lighting, move the lava rocks with a small shovel to allow access to the pilot
located inside the screen.
WARNING: Lava rocks can become very hot. DO NOT touch unless they are
completely cooled.
3. Locate the burner control knob and make sure it is in the "OFF" position.
4. Wearing heat resistant gloves, position a lit long match or lit long neck lighter close to
the pilot. DO NOT lean over the burner while lighting.
5. Push and turn burner control knob to the "PILOT" position. The
pilot should light immediately.
6. If the pilot does not light immediately, turn the burner control knob to
"OFF", wait 5 minutes for gas to clear and repeat the lighting procedure.
If pilot still will not light, refer to the Troubleshooting Section.
7. Flame height can be changed by adjusting the burner control knob between the
"LOW" and "HIGH" positions.
8. Always check burner flames periodically to ensure proper operation. Flames should
be mostly yellow with some blue for best performance.
Note: This appliance is
equipped with a Pilot Light
that allows for safer start-
ups and shutdowns. Pilot
must be lit before Main
Burner can be started.
Main Burner Flame
CAUTION
11
Pilot Flame

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

66926

Tabla de contenido