Bond BHDIY-003 Manual De Usuario página 6

ASSEMBLY INSTRUCTIONS
*Please keep the owner's manual for future reference
*If you have opened the carton and removed all packages,
please disregard STEP 1 and 2. For assembling s ee STEP 3 and 4 directly.
STEP 1
(1) Open the carton and turn it
upside down, and make sure the 4
pieces of the carton are opened up
as shown on the right.
(2) Lift off the carton carefully and
be wary of the accessories inside
falling out. Take out the boxes
containing lava rocks.
(3) Take all the packing materials
out except for the polyfoam
rounding the top of the firebowl.
See Figure A.
STEP 2
(1) Turn the firebowl heads up on a flat ground.
(2) Cut off the binding tape on the polyfoam board and remove all the
polyfoam board rounding the top of the firebowl.
(3) Cut off the tie fastened regulator and set it free for installation to propane tank.
STEP 3
(1) Select a suitable place to build the DIY fire pit, making sure the ground is flat before building.
(2) Build the first layer ring with 11 common bricks (G) and one slot brick (H) used for the gas
hose opening. Place the bricks one by one to create a circle, making sure the slot brick is
not towards the side of where you want to place the control panel. Put the firebowl (I)
beside the brick ring and insert the gas hose through the slot underneath the slot brick (H),
making sure the regulator is on the outside of the ring. See Figure 1.
(3) Build the second layer of the ring, with 9 common bricks (G) and two steel vent bricks (J).
Place the bricks one by one on the first layer ring and take out one brick on the front side
to lay the control plate (attached to the firebowl ) and put the two steel vent bricks (J) on
the left and right side of the ring individually. Make sure the bricks intersect with the first
layer bricks. See Figure 2.
Step1
A
6
Step2
B