Bond BHDIY-003 Manual De Usuario página 13

No gas flow
Regulator is not fully connected
to the tank
Pilot will not
light using a
Gas flow is obstructed
match
Spider webs or insect nest in the
OR
venturi (end of burner tube) or
Main burner
pilot housing
will not light
after pilot is lit
Burner ports are clogged
Flame is obstructed at burner
Appliance emits
ports
a lot of black
smoke when lit
Regulator hose is pinched
No gas flow
Excess flow safety valve has
been activated
Sudden drop
in gas flow
High or gusting winds
Flame blow out
No gas flow
Excess flow safety valve has
been activated
Irregular flame
Burner ports are clogged
pattern or flame
does not come
out of the entire
length of the
burner
OR VISIT OUR WEBSITE UNDER CUSTOMER SERVICE SUPPORT
IF YOU HAVE QUESTIONS OR CONCERNS
PLEASE CALL BOND TOLL FREE #
1-866-771-BOND(2663) OR TO BETTER EXPEDITE
YOUR REQUEST FEEL FREE TO EMAIL US
Customer.service@bondmfg.com
www.bondmfg.com
BOND MANUFACTURING CO.
1700 West 4th Street, Antioch, CA 94509
Check if gas cylinder is empty. If yes, replace.
Check LP tank connection.
Check hose for bends or kinks
Clean the venturi or pilot housing
Insert an opened paperclip into each of the
burner ports to clean them. Ensure the
appliance is off and all parts are cooled before
attempting to clean the burner ports
Make sure all the gas burner ports are free of
any lava rocks or debris to allow the gas to
flow freely.
Check the regulator hose for bends or kinks
Check if gas cylinder is empty. If yes, replace.
Turn the control knob to "OFF", close the LP tank
valve and disconnect the regulator from the tank.
Turn the control knob to "HIGH". Wait 1 minute.
Turn the control knob to "OFF". Reconnect reg-
ulator to LP tank. Open tank valve slowly. Light
appliance as indicated in the "To Light" section.
Increase flame to "High"
Check if gas cylinder is empty. If yes, replace.
See "Sudden drop in gas flow" above
See "Burner will not light using a match"
above.
13