Página 1
• To READ ALL the instructions completely before beginning. • To READ ALL warnings, care, and maintenance information. Para instalación fácil de su llave Delta usted necesitará: • LEER TODAS las instrucciones completamente antes de empezar. • LEER TODOS los avisos, cuidados, e información de mantenimiento.
Página 2
Any damage to this 55 E. 111th Street 420 Burbrook Place faucet as a result of misuse, abuse, or neglect, or any use of other than genuine Delta ® replacement parts WILL VOID THE WARRANTY.
Página 3
▲Specify Finish/Especifíque el Acabado/Précisez le Fini RP18543▲ Base w/Gasket Base y Empaque Embase et joint RP19652 RP40666 Nuts & Washer Hand Spray Tuercas y Arandela Support Assembly Écrous et rondelle RP46683▲ Soporte de la Regadera Hand Piece RP19654▲ de Mano PIeza de Mano Sleeve RP18632▲...
Maintenance If leaks from hand piece: SHUT OFF WATER SUPPLIES. Replace Diverter Assembly (3)–Repair Kit RP19653. 1. Remove handle. Remove sleeve (1). 2. Reinstall handle. Pull on handle to remove extender (2) and diverter assembly (3) from the valve. 3. Detach handle and replace old diverter assembly (3) with a new one. 4.
Página 5
Install spray support assembly (1) from below. Replace nest (2) on spray SHUT OFF WATER SUPPLIES. Drill two 1-1/2" diameter holes in finished suport assembly and rotate 90° to expose screws (3). surface, one for the transfer valve and one for the spray support assembly. NOTE: The length of the braided metal hose limits the distance between the Tighten screws (1) with a regular slotted screwdriver.
Página 6
1-5/8"—1-7/8" (41.3—47.6mm) Remove thin nut (1) from transfer valve (2). Install transfer valve from underside Install handles. If you are installing a cross or lever handle, be sure to install the retention screw (1) into the stem prior to installing the handle. of mounting surface so that the handle stem (3) is 1-5/8"...
Página 7
From tub valves, connect hot and cold water lines to labeled inlets (1) on Remove and discard the test cap and gasket (1) from braided metal hose (2). transfer valve. Either inlet (1) may be used for hot and cold. Use Teflon ®...
Página 8
Turn on water supplies. Pull hose (1) to its furthest extension, pointing it down Install base (1) to nest (2) and tighten. OPTION: Use silicone under the into the tub, turn the diverter handle to the hand shower position. Turn bath valve base if deck is uneven.