Microsoft Surface Hub 55 Manual De Usuario página 4

WARNING: Handling and Site Preparation
Do not attempt to install the device with fewer than the required number of individuals. To reduce the risk of injury due to the size and weight of the device, keep the device upright. When placing the device onto the mount, be certain it is
properly seated before releasing it. Keep the assembly area clear of packing materials. Remove materials after each step.
WARNING: Designated Load Capacity
Wall mounts are rated for a designated load capacity. To reduce risk of personal injury, death, or damage to the device, never exceed the designated load capacity of the wall mount. Refer to the specification section for weights and
load capacities.
WARNING: Tip-Over and Fall Hazard
The wall mount is designed to handle the weight of the device. To reduce the risk of injury or death, never allow anyone to hang from the unit. Never suspend anything other than the designated device.
WARNING: Do Not Attempt to Repair or Modify
Assemble mount components using only fasteners provided by Microsoft, as shown on the parts list. Do not attempt to take apart, open, service, or modify the product, accessories, or power supply. Doing so could present the risk of electric
shock or other hazard. Any evidence of any attempt to open and/or modify this device, including peeling, puncturing, or removing any of the labels, will void the Limited Warranty. Heed all warnings and follow all instructions.
WARNING: Electrical outlet location
To reduce risks related to electric shock, ensure that there is an appropriate electrical outlet within reach of the power cord provided with device to be mounted. Do not use extension cords, or a power cord other than what is provided with the
display assembly.
WARNING: Pinch hazard
When mounting the wall support and installing the device, take care to avoid pinching fingers.
WARNING: Choking hazard
This device or its accessories may contain small parts, which may be a choking hazard to children under 3. Keep small parts away from children.
WARNING: Small children
This device and its accessories are not toys. To reduce the potential for injury, death, or product damage, do not allow small children to play with them. Never allow children to climb on or hang from the device or its stand.
WARNING: Mounting surface orientation
The wall mounting assembly is designed for vertical surfaces only. To reduce the risk of injury or death, do not mount to any surface other than a vertical wall. Do not mount in any orientation other than landscape.
WARNING: Ensure screws are securely tightened
To reduce the risk of the product falling, ensure that all screws are securely tightened to their specified torque values. Do not overtighten as this may cause damage and weaken the holding strength.
This guide outlines the steps for assembling the Surface Hub 55" and Surface Hub 84" floor support mount. These mounts require two people to assemble. Before you begin, make sure you have all of the components in the parts list.
IMPORTANT: Avoid damage to your device.
support it to keep it vertical. The Surface Hub 84" is intended to be lifted only by the lifting handles when being carried. Do not place either device on its face, back, top, or sides.
Specifications
Model Device Stand
weight weight
Surface Hub 55" 105 lb. 60 lb.
Surface Hub 84" 250 lb. 80 lb.
Required tools (not included)
#2 Phillips screwdriver
5mm hex key
6mm hex key (84" only)
8mm hex key
Hand Drill
7/32-inch drill bit
3/16-inch drill bit
Level
Stud finder
Torque Wrench with 5mm and 6mm hex bits
10mm Socket
Further specifications for Surface Hub can be found at http://www.microsoft.com/surface/support/surface-hub
2
The Surface Hub 55" may be supported only by its bottom edge when not supported by the mounting system or lifting handles. Rest it only on its bottom edge, and
Handle Designated
weight load capacity
NA 165 lb.
30 lb. 360 lb.
K