Important Safety Warnings - Microsoft Surface Hub 55 Manual De Usuario

Microsoft Surface Hub
Floor Support Mount Assembly and Mounting
Guide (55"/84")
For wall-mounted installations requiring fl oor support
These instructions assume wood stud and drywall/gypsum board wall construction with 2-by-4 studs spaced 16 inches apart. The supplied mounting screws are for use only in 1/2-inch-thick or 5/8-inch-thick drywall/gypsum board walls less
than 10 feet high. For any other kind of wall, ask a professional installer for advice on the appropriate hardware and methods.

Important safety warnings

Before assembling and mounting Microsoft Surface Hub on the fl oor support mount, read these important safety warnings.
This symbol identifi es safety and health messages in this Device Guide
WARNING: Read Safety & Health Information
Read this guide for important safety and health information. Keep all printed guides for future reference. Failure to follow instructions and properly set up, use, and care for this product can increase the risk of serious injury or death, or damage
to the device or devices. For an online version of this guide and additional support, safety, and health information go to: www.surface.com/support/surface-hub.
WARNING: Installation Experts - Knowledge
To avoid hazards related to improper installation, ensure the installation is performed by people who have read and understand the installation instructions prior to beginning. If you do not have the necessary equipment or expertise, or if you
are not certain that the mounting surface can properly support the Surface Hub, consult a professional installer.
WARNING: Minimum Number of Installers
In order to reduce the risk of injury, Microsoft Surface Hub 55" requires a minimum of two people and Microsoft Surface Hub 84" requires a minimum of four people to perform the installation.
WARNING: Proper Mounting to Wall
To reduce the risk of the device falling, resulting in injury, death, or damage to the device, ensure that:
• The wall strength and mounting method are appropriate to support the weight of this device. While this stand is designed to support the device from the fl oor, the wall must be strong enough to fi rmly hold the anchoring system. The
included fasteners are for use in ½" or thicker drywall/gypsum wall board. For other wall types, ask a professional installer for advice. Reinforcement might be necessary for some materials such as plaster/thin plastic board/wood before
starting installation.
• If your wall is not ½" or thicker drywall/gypsum board 10 feet high or less, purchase the correct hardware to support the device in your installation.
• Use only wall mounts intended for use with the Microsoft Surface Hub model you're mounting.
• Securely tighten all fasteners according to the instructions. Do not over tighten.
WARNING: Proper Installation Environment
To reduce risks related to the environment, the unit must be installed indoors only.
• It is the consumer's responsibility to ensure that structural engineering requirements for potential seismic activity are met per your local requirements. This may require wall reinforcement.
• Do not install near sources of high heat or steam, or where condensation is likely to occur, such as near air conditioners.
• Do not install on a structure that is prone to vibration or movement.
• Do not install in such a way as to block ventilation holes. Allow for proper ventilation according to the device specifi cations.
• Do not install in areas with potentially explosive atmospheres. These areas are often, but not always, posted and can include fueling areas, such as below decks on boats, fuel or chemical transfer or storage facilities, or areas where the air
contains chemicals or particles, such as grain dust or metal powders. The Surface Hub should not be used in these areas. In such areas, sparks can occur and cause an explosion or fi re.
K
EN
1