Worx WX661 Manual De Instrucciones página 10

OPERATINg INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for dry sanding–with
high removal capacity–of wood, plastic, metal,
filler as well as varnished surfaces.
1. ON/OFF SwITCH
Depress to start and release to stop your tool.
2. SwITCH LOCK-ON BUTTON (See Fig. a)
Depress on/off switch (2) then lock on
button (3). Your tool is now locked on for
continuous use. To switch off your tool just
depress and release the on/off switch.
3. VaRIaBLE SPEED CONTROL DIaL
Adjust the variable speed control (1) to
increase or decrease the speed according to
the material and sanding belt specification
to be used (also possible during no load
operation). See the table below for general
guidance on speed selection. Avoid prolonged
10
use at very low speed as this may damage
your sander's motor.
Material
Solid Wood
Veneer
Chipboard
Plastics
Steel
Paint
Removal
Balsa Wood
Acrylic
4. CHaNGING a SaNDING BELT (See Fig. B, C)
waRNING! Remove the main plug
from the socket before changing
sanding belt.
Pull the lever (7) to release the belt tension.
Remove and fit a new belt over both rollers.
Ensure the direction of rotation arrows on the
belt and the sander are the same. Close the
lever to tension the belt.
Belt sander
Speed selection Belt Grit
5-6
2-4
1-5
2-5
5-6
6
1-3
1-2
5. BELT CENTERING CONTROL (See Fig. D)
waRNING! wear eye protection
before carrying out a belt centering
adjustment.
Turn the machine upside down, hold it firmly
with one hand, start the motor and release the
switch immediately after observing tracking
of sanding belt. If abrasive belt runs outward,
turn tracking adjustment knob counter-
clockwise and clockwise if belt runs inward.
Adjust the belt until the outer edge of the belt
is even with the outer edge of the base-plate
(12). Belt life will be greatly increased by
keeping the tracking adjustment set properly.
6. DUST BaG (See Fig. E)
You must use the dust collection bag provided
to collect the dust produced during sanding.
To attach, insert the dust collection bag into
the dust extraction outlet. Make sure the dots
of the outlet are locked in the slot of the dust
bag. When the dust collection bag is full,
remove and empty by opening the zip on the
dust bag (5).
7. aSSEMBLE THE DUST ExTRaCTION
aDaPTER (See Fig. F,G)
Your sander is equipped with a dust extraction
adapter, which is designed for letting you
attach a wet/dry vac for collecting dust better.
80
Insert the suitable size adapter into the outlet
150
until it is secured.
Insert the 35mm adapter (13a) into the outlet
60/80
until it is secured (See F), then insert the 32
100
mm adapter (13b) into the back of the 35 mm
80
adapter (Fig. G).
40/60
8. DRIVE BELT REPLaCEMENT.
waRNING! Remove the main plug
100
from the socket before carrying out
100
a drive belt replacement.
Remove the three screws and the belt cover.
Carefully cut the drive belt if not already
broken and remove from your belt sander.
Fit your new drive belt around the large
pulley. Then install onto the small pulley by
rotating clockwise and pushing the drive belt
shown around the small pulley at the same
time. The drive belt will be a tight fit. Fit the
belt cover and two screws.
EN