D- Using Your Deep Freezer; Start-Up; Control Panel - Ugur UDF 3 SL Guia Del Usuario

D- USING YOUR DEEP FREEZER

Start-up

WARNING!
• This operating manual applies for various device models. Hardware scopes of the models may vary. There
may be diff erences in the pictures.
• Clean inside and all accessories of your product before the first start up (see page 20).
• If your product has been shaken so much during the transportation and positioning, wait for one (1) hour
without running your freezer. Thus, the compressor oil, which may enter into the system, will return back.
You may damage the compressor if you run it without considering this.
• Insert your product's plug into an outlet with alternative current of 220-240V/50 Hz only, which has been
installed according to the regulations. (Picture 8)
PICTURE 8

Control Panel

Indicators and controls on the control panel of your products are shown in Picture 9 below. There is no control panel
in UDF 3 SL model.
PICTURE 9
1) Thermostat setting button for setting the internal temperature of your product: When you put the thermostat setting
to "S" position, you will run fast (super) freezing function that you can use during the initial operation or when you want
a faster freezing.
2) Fast (super) freezing lamp (yellow light) that you can use during the initial operation or when you want a faster fre-
ezing.
3) Alarm indicator that warns you with red light when internal temperature of your product reaches to critical levels.
4) Energy lamp showing your product is powered (Green light).
You will hear a slight sound from the compressor when your product is
running.
Green and red check lamps will light upon turning on your product
Upon first operation of your product, press fast (super) freezing button
in yellow colour. Thus your freezer will make deeper freezing
Yellow Red
45
Green
EN