Cramer 82LM46S Manual Del Usaurio página 13

PROBLEM PROBABLE CAUSE
EN
Cutting height is set
too low.
Mower is
Wet grass clippings
not bagging
are sticking to the
properly.
underside of the
deck.
Blade is unbalanced,
excessively or
unevenly worn.
Mower is
vibrating at
higher speed.
Motor shaft is bent.
Cutting height is set
Motor stops
too low.
while cutting.
Battery has no power.
* If the fault is not solved, you must go to your distributor and/or nearest Authorized
Technical Service.
12
cramer.eu
SOLUTION
Raise the cutting height.
Wait until the grass dries before
mowing.
Replace the blade.
Stop the motor, remove isolator
key and battery, disconnect the
power source, and inspect for
damage. Have it repaired by an
authorised service center before
restarting.
Raise the cutting height.
Charge the battery.
Technical Data (82LM46S)
PROPERTY
Type
Voltage
Width of cut
Height of cut
No-load speed
Self propelled speed
Grassbox capacity
Weight (Without Battery)
Battery Pack
Charger
Sound pressure level
Measured sound power level
Guaranteed sound power level
Vibration level
VALUE
Cordless, battery-operated
82V
46 cm
25 mm - 80 mm
2800 rpm
0.5-1.5 m/s
55 L
31.9 kg
82V220G/82V430G/82V220/82V430
82C1G/82C2/82C6
65.75 dB(A), K : 2.10 dB(A)
PA
L = 85.72 dB(A)
WA
L = 87 .82 dB(A)
WA
< 2.5 m/s
2