EN
4.1 CHARGING THE
BATTERY
DANGER:
Charge the batteries in rooms which are
well-ventilated and comply with applica-
ble regulations in the country of use.
For safety-related information, follow
what is described in chapter 1 of this
manual.
WARNING:
For information and warnings about the
battery and on board battery charger (if
present) follow what is described in the
battery charger manual enclosed with
this document.
WARNING:
When the machine leaves the factory, it is
calibrated to operate with gel batteries. If
acid batteries are installed, it is necessary
to contact the Support Centre to carry out
new calibration.
It is forbidden to use the machine with gel
batteries if the machine is calibrated for
use with acid batteries.
N.B.:
For further information about calibration, please
refer to the information in paragraph 10.1.h.
N.B.:
10 hours are needed for complete battery
charging. Avoid partial recharges.
4.1.a - Charging the battery using the
on board battery charger (if
present) (Fig. 6)
-
Move the machine close to a mains elec-
tricity socket.
-
Remove the battery plug (1) from the sys-
tem socket (2).
-
Connect the battery plug (1) to the on
board battery charger (4) socket (3).
-
Remove the cable (5) from the kit and
connect it to the socket (6) on the ma-
chine, then connect the other end to the
mains electricity socket.
1
2
2
6
5
EN-10
3
1
4
7
Fig. 6