Thetford Tecma 2G Silence Plus Manual De Instalación página 6

Installation, con't.
Connect Electrical
Mount Tank Sensors
Full Tank Sensor / Mid Tank Sensor (Optional)
■ Clean the surface of the side of the tank at the top – approximately
on the left-right centerline with isopropyl alcohol (not included) where
the Full Tank Sensor will be mounted. When thoroughly clean and
dry, fi rmly press the sensor in place.
Wires can point in any direction – the sen-
NOTICE
sors directional orientation does not affect its
operation.
■ Follow the same procedure for the Mid Tank Sensor, except it should
be mounted on the left-right centerline approximately half way up the
tank side.
■ The Full Tank Sensor is mounted at the highest point on the tank
minus one inch (to allow for a few additional fl ushes) from tank
capacity, or where the installer wants the Tank Full indication to be.
■ The Tank Sensors should be mounted near the center line of the
tank.
A6.1
A6.2
Keep wires away from sensor pads to avoid
NOTICE
false readings.
A6.1
A6.2
Refer to Fig. B and Fig. G.
Ref. Description
A6.1 FULL Tank Sensor - The sensor has a removable cover over
the pressure-sensitive adhesive pad.
A6.2 Mid Tank Sensor (Optional) - The sensor has a removable
cover over the pressure-sensitive adhesive pad.
B5 The area for adhesion should be thoroughly cleaned with alco-
hol or equivalent, and dried, prior to mounting the sensor.
98269 Rev. B (05.30.18)
Holding Tank
Holding Tank Centerline
B5
Fig. F
Tecma 2G Silence Plus RV Owner's & Installation Manual
6