Nuova Simonelli MICROBAR Instrucciones De Manejo página 46

At the end of installation, the device is

switched on and taken to rated operating
conditions, leaving it in a state in which it
is "ready for operation".
The device is then switched off and the
whole hydraulic circuit is bled of the first
lot of water in order to remove any initial
impurities.
The device is then refilled and taken to
rated operating conditions.
After reaching the "ready for operation"
condition, the following dispensing ope-
rations are carried out:
- 100% of the coffee circuit through
the coffee dispenser (for more than one
dispenser, this is divided equally);
- 100% of the hot water circuit through
the water dispenser (for more than one
dispenser, this is divided equally);
- opening of each steam outlet for 1 minu-
te.
At the end of installation, it is good prac-
tice to draw up a report of the operations.
Basic rules must be observed when using

any electric appliance.
In particular:
• do not touch the appliance when
hands or feet are wet;
RISK OF ELECTRIC SHOCK
• do not use the appliance when barefo-
ot;
• do not use extensions in bath or sho-
wer rooms;
• do not pull the supply cord out of the
socket to disconnect it from the mains;
44
CAUTION
Fig. 6
• do not leave the appliance exposed to
atmospheric agents (rain, sun, etc.);
• do not let the appliance be used by
children, unauthorised staff or staff
who have not read and fully understo-
od the contents of this handbook.
Before servicing the appliance, the autho-

rised technician must first switch off the
appliance and remove the plug.
To clean the appliance, set the machine to

the "0" energy level, that is, "WITH THE
MACHINE SWITCHED OFF AND THE PLUG
REMOVED FROM THE MAINS" and follow
the instructions in this handbook.
If the appliance breaks down or fails to work

properly, switch it off. Any intervention is
strictly forbidden. Contact qualified experts
only.
Repairs should only be made by the manu-
facturer or authorized service centres. Only
original spare parts must be used. Failure to
observe the above, could make the appliance
unsafe.
EN
Fig. 7
Fig. 8