Need For De-Scaling Cycle - Nuova Simonelli MICROBAR Instrucciones De Manejo

EN
DISPLAY
WASHING CYCLE
IS NEEDEDGIO
WASHING THE MILK
CIRCUIT IS NEEDED
SHUT DOWN CLEAN
NEED FOR DE-SCALING
CYCLE
CAUSA EFFECT
The set number
The message will
of cycles pro-
appear on the
grammed befo-
display but the
re washing, has
machine will con-
been exceeded.
tinue to deliver
drinks.
The set number The
of hours pro- will appear on
grammed from the display but
time of last milk the machine will
based drink continue to deli-
before washing, ver drinks.
has been exce-
eded.
An end of ser- An end of servi-
vice wash was ce wash must be
set for the deli- performed before
very unit during the machine is
the program- switched off.
ming stage.
The number
This message is
of litres after
displayed but the
which a de-
machine will con-
scaling cycle
tinue to dispense
is required has
drinks
been exceeded.
SOLUTION
Do a washing
cycle (see para-
graph WASHING
THE DELIVERY
UNIT AND MILK
FOAMER)
message Perform a washing
cycle for the milk
foamer only. As
in the case of a
complete washing
cycle, you must
keep the key pres-
sed down
seconds without,
however, inserting
cleanser tablets
for this group's
washing.
(See only points
1,2,3,4 of the para-
graph 'WASHING
THE DELIVERY
UNIT AND MILK
FOAMER')
Press the ENTER
key as shown on
the display.
machine will auto-
matically perform
an end of service
wash, dispensing
approx.
50cm3 (3.0512 cu
in) of water and will
then switch off.
Carry out a de-
scaling
(SEE the relevant
section entitled
" D E - S C A L I N G
CYCLE")
NOTE
for 5
The
cycle
73