Cleaning And Maintenance; Cleaning The Outside Of The Machine - Nuova Simonelli MICROBAR Instrucciones De Manejo

Ocultar thumbs Ver también para MICROBAR:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

EN
9.
CLEANING AND
MAINTENANCE
NEVER use water jets to clean the machine.
During maintenance/repairs, the parts used must be
able to guarantee compliance with the safety and
hygiene requirements envisaged for the device.
Original replacement parts can offer this guarantee.
After repairs to/replacement of a part that comes
into contact with foods or water, it is necessary to
carry out a washing procedure or to follow the steps
indicated by the manufacturer.
9.1
CLEANING THE
OUTSIDE OF THE
MACHINE
Before carrying out any cleaning operations, set the
machine to the "O" energy level, (machine switched
off and plug removed from the mains).
Never use solvents, chlorine-based products,
abrasives.
Cleaning the work area: remove the worktop, lifting
it up from the front and sliding it out. Remove the
water collection dish underneath and clean eve-
rything with hot water and cleansers.
Cleaning the external surfaces: To clean the
panels, use a soft, damp cloth.
9.2
CLEANING THE
DELIVERY UNIT AND
THE MILK FOAMER
NOTE: Follow the instructions on the label applied on
the inside of the front door.
WARNING
Fig. 35
CAUTION
NOTE: Before starting the washing cycle check and
refill the level of water in the water tank.
The machine is equipped to wash the delivery unit
with detergent tablets and the milk circuit with liquid
cleansers.
The machine will begin a wash cycle that consists
of hot water deliveries alternated with pauses. The
whole cycle lasts approximately 4 minutes.
We recommend that you carry out a WASHING
CYCLE at least once a day using special cleansers.
CAUTION
RISK OF INTOXICATION.
We remind you not to interrupt a washing cycle
using detergent tablets once started, otherwi-
se detergent residues may remain inside the
machine.
In order to execute the washing procedure proceed
as follows:
1. Position a container with water beside the
machine.
2. Put the suction tube inside it.
3. Add the specific cleaning product (20 ml [0.005
Gal] of Puly Milk).
Fig. 36
Fig. 37
67

Publicidad

Tabla de contenido
loading

Tabla de contenido