1.1 UNPACKING
• Removeall packagingmaterial.
• Removeseparateaccessory box.
• Removecarton off the generator.
1.1.1 ACCESSORY B OX
Checkall contents (Figure1). If any parts are missing or damaged
locate an authorizeddealer at 1-888-436-3722.
Contentsinclude:
• 2-Axle Pins
•
Oil Filter
• 2- WheelSpacers
•
Air Filter
• 2- Hair Pins
•
SparkPlug
• 2- Wheels
•
SparkPlug Wrench
• 1 - FrameFoot
•
Shop Towel
• 1 - FrameBolt
•
1 Quart SAE 30 Oil Bottle
• 1 - FrameFlat Washer
•
Oil Funnel
• 3 - FlangeNuts
•
2 - Vibration Mounts
Figure 1 - Accessory Box
Referto Figure2 and installthe wheelkit andframe foot as follows:
1. Slidethe Axle Pin through the Wheel, WheelSpacer (Washer)
and the Frame.
2. Installthe Hair Pin to the Axle Pin to secure the wheel. Repeat
for the opposite side.
3. Secure the Vibration Mounts to the Frame Foot with the
includedlocking nuts.
4.
To install the Frame Foot, remove the lock nut from the
Vibration Mount stud.
5. Place the Frame Foot on the Vibration Mount stud and
re-install the lock nut. Tighten the nut completely.
6. Install the FrameBolt through the FrameWasher,Frame and
Framefoot. Securewith a flange nut.
Figure 2 - Wheel and Foot Assembly
ASSEMBLE
FRAME
FOOT
SECURE WHEEL
AND AXLE WITH
HAIR PIN
t
1.2 ASSEMBLY
Read entire Owner's Manual beforeattemptingto assemble or
operate the generator. The generator requires some assembly
prior to using it. If problems arise when assemblingthe generator,
pleasecall the GeneratorHelplineat 1-888-436-3722.
1.2.1 ASSEMBLING THEWHEEL KITANB FRAMEFOOT
The wheel kit is designedto greatly improvethe portability of the
generator. Y ou wilt needthe following tools to install the wheel kit:
• Pliers
• 1/2" (13mm) Wrench
• SocketWrench with a 1/2" (13mm) socket.
NOTE:
The wheelsare not intendedfor over-the-road use.
RE-USE THIS
NUTFROM
VIBRATION --_
MOUNT
WHEEL SPACER
FRAME
WASHER
FLANGE
NUT
INSTALL FRAME FOOT
FRAME
BOLT
SLIDEAXLE
THROUGH WHEEL
ANDWHEEL
SPACER