4
General Cleaner Operation
•
To prevent damage to the cleaner, be sure to adhere to the following guidelines:
•
Remove the cleaner from the pool after the cleaning cycle is completed.
•
Store on the caddy out of direct sunlight or inclement weather.
•
Never lift the cleaner out of the pool by the floating cable. Always use the lift feature to
remove cleaner from the pool.
•
Take additional care when lifting the cleaner out of the pool. It becomes heavier when
filled with water.
•
Always remove the cleaner from pool when super chlorinating or adding acid.
•
Do not handle cleaner while it is in operation.
•
Always make sure the cleaner head is fully submerged before you begin
operation.
•
Clean the filter canister after each cleaning cycle.
•
Do not leave your cleaner in the pool on a permanent basis.
•
At the end of each cycle, remove the cleaner from the pool.
•
Start at the cleaner head and untangle any coils in the cable before storing
the cleaner.
The Polaris robotic cleaner includes a safety feature that automatically stops the
cleaner if it is powered on but not submerged in water. For pools equipped with
a beach area, this safety feature is programmed to drive the cleaner in reverse
and back into the pool when the impeller is out of the water.
CAUTION
IMPORTANT
Page 13