Start / Stop Cleaning And Adjust Cleaning Time; Set Cleaning Mode - Polaris Robotic 9650iQ Sport Manual Del Usuario

Page 20

Start / Stop Cleaning and Adjust Cleaning Time

NOTE: During system configuration, the chosen pool shape defines robotic patterning cycles/run
time
The factory default cleaning surface setting is Floor and Wall
1. From the main app screen and with cleaner submerged in the water, press
START to begin operation.
2. The app displays the time remaining for the selected cycle in hours and
minutes.
To increase or decrease the cycle time during cleaning,
press the (+) and (–) buttons.
-Time adjusts up or down in 30 minute increments.
-Minimum run time is 30 minutes.
-Maximum run time is 3 hours 30 minutes.
-The control unit displays the same countdown and cycle setting as the app.
3. Press STOP to interrupt and cancel an in-progress cleaning cycle.

Set Cleaning Mode

1. From the main screen, select Cleaning Mode to view options.
2. Choose between Quick Clean, Deep Clean, Waterline Only, and Custom
modes. The selected mode is highlighted.
3. In Custom mode, select the cleaning surface and cleaning intensity from the
on-screen icons. Selections will be highlighted.
-Surface choices include, Floor Only, Floor and Wall, or Waterline Only
-Intensity options are Standard Intensity or High Intensity.
Press Save to keep settings or X to cancel and go back.
4.
NOTE: Cleaning mode will be set for all current or future cleaning cycles unless adjusted on
the control box or within the app.
5. Press X to leave the Lift System page and return to the main screen.