Hydromassage Activation; Underwater Spotlight - Jacuzzi lodge MLS Manual De Instalación

Clearray™ operates automatically and is dependent on pump
activation (or the filtration pump, where present) during the fil-
tering cycle, it remains off when the hydromassage, blower or even
just the spotlight are on (as it is presumed that there is somebody
in the tub); Clearray™ (where a filtering cycle is active) begins oper-
ating once again 40 minutes subsequent to switching off the afore-
mentioned functions.
Rapid Filtering ("Boost")
( "hydro" and "hydro+blower" versions only)
This is recommended after intensive use of the hot tub and/or is as-
sociated with chemical treatment of the water, to favour the disso-
lution of substances used for disinfection.
To activate this function, press and hold down the "Pump"
key for 5 seconds. The display will show the message boo.
The operation lasts 45 minutes (this time period cannot be
modified) during which the pump is activated together with
Clearray™ (where present).
NOTES:
- If the heater is on, it will continue to run normally, unless the sys-
tem is configured for limitation of electrical consumption.
- the filtration pump is activated in "blower" models.
The function stops:
- when the aforementioned time expires
- when another function is activated.
- pressing the key Pump" again
NOTE: if you need to activate the anti-freeze protection during rap-
id filtering, rapid filtering will be stopped to allow the anti-freeze
protection to be started.

Hydromassage activation

This function is activated by pressing the "Pump" key
in some models, with the key
In "hydro with heater" and "hydro +blower with heater"
models, the first time the key is pressed starts the pump at a
low speed (if not already on to heat the water or for
the second time starts the high speed, and the third time
turns it off.
In "hydro with heat exchanger" models, the hydromassage
pump is turned on by the key
the filtering pump on and off (if not already on to heat the wa-
ter or for filtering).
In "hydro+blower with heat exchanger" models, the oper-
ation is as follows:
- the first time the key is pressed turns on the filtering pump
(if not already on to heat the water or for filtering);
- the second press turns on the hydro pump;
- the third time the key is pressed turns off the filtering pump
(not available while heating the water or filtering);
- the fourth press turns off the hydro pump;
.
:
filtration),
whereas the key " turns
In "blower" models, the key
and off (if not already on to heat the water or for filtering).
NOTES
The function turns off automatically after 20 minutes (if not turned
off by the user).
Blower activation (where present)
Press the key "Blower"
(the LED comes on).
The blower can be activated either in conjunction with, or
separately from, the pump (when the system turns on, the blow-
er is always off ).
The blower stays on for 20 minutes. It can be shut off before that
by pressing the key again.
If you want to use the blowers for aroma therapy (if installed),
insert the perfume cartridge in the compartment located under
the cover; once this cartridge is finished, it can be replaced with
a new one (cartridges are available from authorised Jacuzzi® deal-
ers and service centres).
CAUTION: Replace used cartridges when the blower is off.

Underwater spotlight

or,
Press the key "Light"
the wall of the tub (the LED comes on).
The spotlight will stay on for two hours, but it can be turned
off before that by pressing the key again. Refer to the user's man-
ual for the operation of the various sequences of colours.
Temporary shutdown of system (stand-by)
This function lets you suspend operation of all system devices for a
period of 60 minutes (this value cannot be changed) so that you
can perform routine maintenance without having to disconnect
the power supply.
CAUTION
If you need to access the electronic parts, parts that are
normally powered, or the rotating parts of the pumps,
you must disconnect the electric power by turning off
the all-pole circuit breaker.
To activate the function, press and hold the "Light"
for about 8 seconds: the display will show the message "Sby" fol-
29
turns the filtering pump on
to activate the air compressor
to activate the spotlight located on
key