Jacuzzi lodge MLS Manual De Instalación página 32

Water leakage from shaft
of the pump (rotating joint
between the pump and the motor)
The motor does not start
The motor stops
The blower does not operate
*
: This type of repair requires the intervention of qualified personnel.
Contact your Jacuzzi® dealer or an authorised Service Centre.
It is the responsibility of the installer/owner to ascertain compliance with specific local regulations prior to installation. Jacuz-
zi Europe S.p.A. gives no guarantee in this respect and declines all responsibility regarding the compliance of the installation
performed.
Low water level
Motor bearings worn or faulty
The impeller rubs against the pump body
Solid bodies in the pump
Pump mechanical seal worn or defective
No power
Main switch has tripped
Voltage too low
Circuit breaker has tripped
Incorrect or faulty connections
Shaft and impeller blocked
Motor windings burnt
Faulty contact on motor
start-up
The function has ended
Overload
Power supply cables not suitable
No power
The button or has not been fully pressed
Main switch has tripped
Circuit breaker has tripped
Faulty motor
32
Add water up to the
normal level
*
*
*
*
Turn on the mains switch
Turn on switch
Contact an electrician or the organization
that provides electricity
Reset breaker
*
*
*
*
Press the key or again
Let the motor cool,
the problem should disappear.
If it persists, see *
Consult an electrician
Turn on the main switch
Press the button again
Turn on switch
Reset breaker
*