Westinghouse WH1000i Manual Del Propietário página 25

NOTICE
The engine is equipped with a low oil shutdown
switch. If the oil level becomes low, the engine will
shut down and will not start until the oil is filled to the
proper level.
Be sure the engine has the proper oil level before
using. Failure to verify that the engine has the proper
oil level could result in engine damage.
Disconnect all loads from the inverter before starting.
Failure to verify all loads are disconnected prior to
starting the inverter could result in damage to the
connected appliances.
N OTE: There are key areas that need to be
addressed when starting the inverter. These
key areas are highlighted in yellow.
1. Turn the fuel tank vent to the ON position (see
Figure 21).
Figure 21 – Fuel Tank Vent
2. Turn the engine/fuel control switch to the ON
position (see Figure 22).
Figure 22 – Engine/Fuel Control Switch (WH1000i
Shown)
OPERATION
3. Pull the choke knob out to the ON position (see
Figure 23).
Figure 23 – Choke Knob (WH1000i Shown)
4. Firmly grasp and pull the recoil handle slowly until
you feel increased resistance. At this point, apply
a rapid pull while pulling out from the inverter (see
Figure 24).
Figure 24 – Recoil Handle (WH1000i Shown)
5. As the engine starts and stabilizes, gradually push
the choke knob back in to the OFF position.
25