Operation - Bartscher E 5230 Manual De Instrucciones

•
Should the combi steamer be installed on table of stainless steel or other combi
steamer, it is not recommendable, to use the higher insertions than those, at which
the user can look into the container.
•
For safety reasons, after installation of the device, the label
container! Danger of burns! ", which is located in the package must be attached to
the combi steamer at a height of 1600 mm from the floor.

5.2.2 Operation

•
Clean the oven and its accessories carefully before use (see 6 „Cleaning and
maintenance").
•
Before approving the oven for the use ensure it is installed properly and placed in
stable and level place and that the electrical and cold water supply connections are
properly set up.
CAUTION!
Preheat the oven before cooking/baking using its preheat mode
(see chapter „Preheating", page 71).
•
Once the device is connected to the power supply, it will remain in standby mode.
•
The device's control panel is equipped with a dial
To set the desired parameters, turn the dia
M
press the dial
- 62 -
.
M
.
l M
; to confirm the values entered,
„Hot liquid in