Trimmer Functions - Beninca CELL.P Guia De Inicio Rapido

4) Send an opening control signal through the OPEN input.
5) The door leaves should open. If not, with stopped motor, it is sufficient to invert the move wires
of the motor (MOT/MOT) of the motor and the limit switches (SWO/SWC), if used.
6) Adjust Times and operating Logics.
TW It allows the maximum duration of opening and closing.
It must be preset approx. 4s more with respect to the actual stroke time of the
system.
The adjustment ranges from 3s to 180s maximum.
TCA It allows to adjust the automatic closure time.
The adjustment ranges from 3s to 180s maximum.
Dip-Switches
DIP1
DIP2
DIP3
DIP4
DIP5
DIP6
With all DIPs on ON, the control unit switches to SERVICE MAN mode.
The SWO and SWC inputs are deactivated.
The OPEN/CLOSE push-buttons must be kept pressed during operation. The opening of the
STOP input stops the motor.
When DIP1 is moved to ON, the board indicates that the torque has been applied during a
number of flashes (from 1 to 4) of the DL2 green LED, followed by a 3-s interval.
The max torque is indicated with DL2 green LED with fixed light.
To increase the torque, press P1. The DL2 LED changes the number of flashes to indicate the
10

TRIMMER FUNCTIONS

DIP-SWITCH FUNCTION
Function Description
To be used for the programming of the torque, as shown
TORQUE hereunder. After presetting the parameters, move to OFF
again.
The automatic closure is enabled or disabled.
TCA Off: disabled automatic closure.
On: enabled automatic closure.
The operating mode of input DAS/PHOT is selected:
DAS/PHOT Off: partial reversion (3s) at activation of safety edge.
On: total reversion at activation of edge/photocell.
Off: during closure, if SWC is pressed, the motor is
blocked.
SWC MODE On: during closure, if SWC is pressed, the motor continues
its closing movement for further 2 seconds or until the
SAFETY EDGE is activated.
Select how OPEN input (13) works:
ON: during opening an OPEN command is ignored
BLI
During closing an OPEN command reverse the motion.
OFF: Works according DIP 6 setting
The operating mode of input 13 (Open) is selected.
Available only with DIP 5 OFF
OPEN/PP
On: PP Operation: OPEN > STOP > CLOSE > STOP>.
Off: OPEN operation always.
SERVICE MAN MODE
ADJUSTMENT OF THE TORQUE (DIP1:ON)