Weekly Timer - RHOSS H58624/B Instrucciones De Uso

2.2.7 Weekly Timer

At the Function setting page, by touching "Weekly timer", it will go to the setting page as shown below.
At the "Weekly timer" setting page the weekly timer can be set to "On" or "Off".
At the "Weekly timer" setting page, by touching the desired day (Monday ~ Sunday), it can be set "Valid" or "Invalid". It is possible to set
three timing periods, each of which can be set to "Valid" or "Invalid".
Then, by touching the "Save" icon, this setting will be saved.
NOTE

"Weekly Timer" is a repetitive weekly timer.

Three periods can be set for each day. The start time should be earlier than the end time for each period, otherwise this setting will be
invalid.

This function allows the timer to be set for each day of the week, the day of the week can be set as:
"Active" indicates that the daily timer is active
o
"Not Active" indicates that the daily timer is not active
o
"Vacation" indicates that the daily timer is active / not active based on the release of the Vacation Program function (see 2.2.8)
o

When the weekly timer has been activated, the control panel will act based on the current mode and setpoint temperature setting.

The priority of the timers is as follows: Time bands (high) - Timer - Preset mode - Weekly timer (low)

The setting is memorized and re-proposed in case of power failure (see 2.6.1 On/Off memory).

The default value is Off.
2.2.8 Holiday Release (Holiday program)
At the Function setting page, by touching "Holiday release", it will go to the corresponding setting page, where it can be set to "On" or "Off".
NOTE

On the days of the week of the "Weekly timer" set as a holiday it is possible not to activate or activate the unit based on the preset daily
timers, using the Holiday program function:
if Holiday Program is On the unit will not be active on "holiday" days;
o
if Holiday Program is Off, the unit will be active on "holiday" days based on the preset Daily Periods.
o

The setting is memorized and re-proposed in case of power failure (see 2.6.1 On/Off memory).

The default value is Off.
2.2.9 Disinfection
At the Function setting page, by touching "Disinfection", it will go access to "Disinfection" setting page.
At the "Disinfection" setting page, it can select the disinfection clock, disinfection temperature and disinfection week and the corresponding
setting page will pop up at the right side.
Then, this setting will be saved by touching the "Save" icon.
NOTE

This setting can be activated only when "Water tank" is set to "With".

"Disinfection" can be activated no matter if the unit is turned on or off. This mode will take priority over the "Hot water" mode.

If "Emergen.mode", "Holiday mode", "Floor debug", "Manual defrost" or "Refri. recovery" has been activated, this function cannot be
activated at the same time.

If "Disinfection" has been activated, "Emergen. mode", "Holiday mode", "Floor debug", "Manual defrost" or "Refri. recovery" setting will fail
and a window will pop up, saying "Please disable the disinfect mode!"

When disinfection operation fails, the display panel will tell "Disinfection fail!". Then, by pressing OK it will be cleared.
< Save
40
ELECTA-ECO