2.4 VIEW SETTING
At the Menu page, by touching "VIEW", the control panel will go to the view page, as shown in the figure below.
This function allows to view the status of the unit, allows to view the unit's parameters and to view active alarms.
2.4.1 Status Viewing
At the "VIEW" page, by touching "Status", it is able to view status of the unit, as shown in the figure below.
No
Displayed Name
1
Compressor
2
Fan
3
Unit status
4
HP-pump
5
Tank heater
6
3-way valve 1
7
3-way valve 2
8
Crankc. heater
9
HP-heater 1
10
HP-heater 2
11
Chassis heater
12
Plate heater
13
Defrost
14
Oil return
15
Thermostat
16
Other thermal
17
2-way valve
18
HP-Antifree
19
Gate-Ctrl.
20
4-way valve
21
Disinfection
22
Flow switch
Viewable Status
Full Name
Status of the compressor
Status of the fan
Status of the unit
Status of the water pump
Status of the water tank heater
Status of the 3-way valve 1
Status of the 3-way valve 2
Status of the compressor crankcase heater
Status of the heater 1 for the main unit
Status of the heater 2 for the main unit
Status of the Chassis heater
Status of the heat exchanger heater
Status for the system defrosting
Status of the system oil return
Status of the thermostat
Status of other thermal source
Status of the 2-way valve
Status of antifreeze
Status of the door guard
Status of the 4-way valve
Status of disinfection
Status of the flow switch
45
ELECTA-ECO
Status
On/Off
On/Off
Cool/Heat/Hot water/Off
On/Off
On/Off
NA
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
Off/Cool/Heat
On/Off
On/Off
On/Off
Card in/Card out
On/Off
Off/Running/Done/Fail
On/Off