Safety Warnings - STEINEL PROFESSIONAL BHG 360 Li-Ion Manual Del Usuario

GB Translation of the
original operating instructions
Please familiarise yourself with these operating instructions
before using this product, because prolonged reliable and
trouble-free operation will only be ensured if it is handled
properly.
We hope your new hot air tool will give you lasting satisfaction.

Safety warnings

Read and observe this information
before using the tool. Failure to
observe the operating instructions
may result in the tool becoming a
source of danger.
When using electric power tools, ob-
serve the following basic safety pre-
cautions to avoid electric shock as
well as the risk of injury and fire.
Used carelessly, the tool can start an
unintentional fire or injure persons.
Check the tool for any damage
(mains connection lead, housing etc.)
before putting it into operation and
do not use the tool if it is damaged.
Do not leave the tool switched on
unattended.
Children should be supervised to
make sure they do not play with
the device.
First time of use
A small quantity of smoke may
develop when the tool is used for
the first time. This smoke is caused
by binding agents released from
the heater's insulating film during
the first time of use.
To let the smoke escape quickly,
the tool should be set down on its
About this document
Please read carefully and keep in a safe place.
- Under copyright. Reproduction either wholly or in part only
with our consent.
- Subject to change in the interest of technical progress.
standing surface. The area you are
working in should be well ventilated
when using the tool for the first time.
Any smoke coming out of the tool is
not harmful!
Take the ambient
conditions into account.
Do not expose electric power tools
to rain. Do not use electric power
tools when they are damp or in a
damp or wet environment. Exercise
care when using the tool in the
proximity of flammable materials.
Do not direct the tool at one and the
same place for a prolonged period.
Do not use in the presence of an
explosive atmosphere. Heat may be
conducted to flammable materials
that are hidden from direct sight.
Protect yourself from
electric shock.
Avoid coming in contact with
grounded objects, such as pipes,
radiators, cookers or refrigerators.
Do not leave the tool unattended
while in operation.
– 12 –
Safety warnings
Store your tools in a
safe place.
After use, set the tool down on its
standing surface and let it cool
before putting it away.
When not in use, tools must be
stored in a dry, locked room out of
children's reach.
This tool may be used by children
aged 8 or above and by persons
with reduced physical, sensory or
mental capabilities or lack of experi-
ence and knowledge if they are su-
pervised or have been given instruc-
tions on how to use the tool safely
and understand the hazards in-
volved.
Do not allow children to play with
the device.
Children are not allowed to clean or
carry out maintenance work on the
device without supervision.
Do not overload
your tools.
Your work results and safety will be
enhanced if you operate the tool
within the specified output range.
Do not carry the tool by the power
cord. Do not unplug the tool by
pulling on the power cord. Protect
the power cord from heat, oil and
sharp edges.
Beware of toxic gases and
fire hazards.
Toxic gases may occur when work-
ing on plastics, paints, varnishes or
similar materials.
Beware of fire and ignition hazards.
For your own safety, only use ac-
cessories and attachments that are
specified in the operating instruc-
tions or recommended or specified
by the tool manufacturer.
Using attachments or accessories
other than those recommended in
the operating instructions or cata-
logue may result in personal injury.
Repairs must only be carried
out by a qualified electrician.
This electric power tool complies
with the relevant safety regulations.
Repairs should only be performed by
a qualified electrician. Otherwise the
user may run the risk of accidents.
If this tool's main power cord is
damaged, it must be replaced by
the manufacturer or its customer
service department or a similarly
qualified person so as to avoid
hazards.
– 13 –