Installation Instructions for EcoSalt
INSTALLING THE POWER SUPPLY:
Select a convenient well-ventilated location within one metre of filter equipment and mount the Power
Supply vertically onto a dedicated pool equipment wall or post 1.5 metres above ground level.
Supply should not be located within 3 meters of the pool water.
Hardwire the Power Supply cord into a suitable weatherproof outlet as per local standards and local
government regulatory requirements. The Power Supply may be interlocked to switch on/off with the pump
via an external timer, or simply powered at all times.
Two self-tapping screws and wall plugs have been provided for fast and simple installation. The drawing on
page 17 shows the dimensions between the drill entry points. Use a 6mm masonry drill bit when fitting the
power supply to a brick or concrete wall. When mounting to a post drill pilot holes and fit screws provided.
Once screws are in position simply hang chlorinator via mounting slots at the rear of the top panel.
Note: the additional mounting slot at the base can be used to help secure the unit.
INSTALLING THE IN-LINE CELL:
The Cell can be installed vertically or horizontally in a position that allows for easy removal and cleaning.
The Cell MUST be positioned after all accessories such as heater or pool cleaner, but before it divides if
there is more than one return to pool line.
NOTE: The ORP Probe and Manifold MUST be installed prior to the Cell and at least 200mm from the Cell
inlet.
NOTE: The Power Supply must be kept away from acid and other chemical storage areas. Acid and
chemical vapours will corrode the electronics inside the Unit. It must also be kept away from heat sources.
Good ventilation is necessary for correct operation.
IMPORTANT: If the chlorinator must be mounted
restrictions, it must be fully sheltered so that water does not enter the unit. If water enters the
chlorinator when mounted in this position the warranty will be void.
!
)!
REDOX
!
horizontally (Face Up), due to installation
The Power