Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
STEP
2
Install the HeaderBracket
You can attach the header bracket either to the wall above the
garage door, or to the ceiling. Follow the instructions which will
work best for your particular requirements. Do not install the
headerbracket over drywall. If installing into masonry, use
concreteanchors(not provided).
WALL HEADERBRACKET INSTALLATION
• Center the bracket on the vertical centerline with the bottom
edge of the bracket on the horizontal line as shown (with the
arrow pointing toward the ceiling).
• Mark the vertical set of bracket holes (do not usethe holes
designated for ceiling mount). Drill 3/16" pilot holes and fasten
the bracket securely to a structural support with the hardware
provided.
HARDWARESHOWN ACTUALSIZE
5/16"x9x1-5/8"
CEILINGHEADER BRACKET INSTALLATION
• Extend the vertical centerline onto the ceiling as shown.
• Centerthe bracket on the vertical mark, no more than 6" (15 cm)
from the wall. Make sure the arrow is pointing toward the wall.
The bracket can be mounted flush against the ceiling when
clearance is minimal.
• Mark the side holes. Drill 3/16" pilot holes and fasten bracket
securely to a structural support with the hardware provided.
Ceiling Mounting Holes
I
k
, __
Wall Mounting Holes
Wall Mounting Holes
The nail hole is for
positioning only.
You must use lag screws
to mount the header bracket.
Header
-
Wall
2x4
Structural
Support
Horizontal
Line
_
/
7
Vertical
Centerline
of Garage Door
LagScrews
5/16"-9xl - 5/8"
Door Spring
J
Highest Point of
Garage Door Travel
Garage
-
Door -
Vertical
Centerline
of Garage Door
6" (15 cm) Maximum
Door
Spring
Lag Screws
5/16"-9xl -5/8"
HeaderWall
13
Publicidad
Capítulos
Tabla de contenido
