Programming; Toaddor Reprograma Hand-Heldremotecontrol; To Eraseall Codes; 3-Function Remotes - Craftsman 139.536481DM Manual Del Propietário

PROGRAMMING
NOTICE:If this Security+ ®garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver of
the garage door opener, which provides security against code-theft devices, will be circumvented. Theowner of the copyright in the
garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
Your garage door opener has already been programmed at the factory to operatewith your hand-held remote control. The door will open
and close when you press the large push button.
Below are instructions for programming your opener to operatewith additional Security+ ®315 MHz remote controls.
ToAddor Reprograma Hand-heldRemoteControl
USINGTHE "LEARN" BUTTON
1. Press and releasethe "learn" button on the
motor unit. The learn indicator light will
glow steadily for 30 seconds.
3. Releasethe button when the motor unit
lights blink. It has learned the code. If light
bulbs are not installed, two clicks will be
heard.
\1/
2. Within 30 seconds, press and hold the
button on the hand-held remote* that you
wish to operateyour garage door.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or keyless entry
you wish to use.
*3-Function Remotes (315 MHz)
If provided with your garage door opener, the large button is
factory programmed to operate it. Additional buttons on any
Security.I.®3-Function remote _ _
or compact remote can be
programmed to operate other
Security+ ®garage door
openers.
35