To Add, Reprogram Or Change A Keylessentry Pin - Craftsman 139.536481DM Manual Del Propietário

1/2 hp, 315 mhz
Ocultar thumbs Ver también para 139.536481DM:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ToAdd, Reprogram or Change a Key/ess Entry PIN
NOTE: Your new KeylessEntry must be programmed to operateyour garage door opener.
USINGTHE "LEARN" BUTTON
1. Press and releasethe "learn" button on
motor unit. The learn indicator light will
glow steadily for 30 seconds.
3. Releasethe button when the motor unit
lights blink. It has learned the code. If light
bulbs are not installed, two clicks will be
heard.
\1/
2. Within 30 seconds, enter a four digit
personal identification number (PIN) of
your choice on the keypad. Then press
and hold the enter button.
To changean existing, knownPIN
If the existing PIN is known, it may be changed by one person
without using a ladder.
1. Press the four buttons for the present PIN, then press and hold
the # button.
The opener light will blink twice. Releasethe # button.
2. Press the new 4-digit PIN you have chosen, then press Enter.
The motor unit lights will blink once when the PIN has been
learned.
Test by pressing the new PIN, then press Enter. The door should
move.
Toset a temporaryPIN
You may authorize access by visitors or service people with a
temporary 4-digit PIN.After a programmed number of hours or
number of accesses, this temporary PIN expires and will no longer
open the door. It can be used to close the door evenafter it has
expired. To set a temporary PIN:
1. Press the four buttons for your personal entry PIN (not the last
temporary PIN), then press and hold the _, button.
The opener light will blink three times. Releasethe button.
2. Press the temporary 4-digit PIN you havechosen, then press
Enter.
The opener light will blink four times.
3. To set the number of hoursthis temporary PIN will work, press
the number of hours (up to 255), then press _,.
OR
3. To set the number of timesthis temporary PIN will work, press
the number of times (up to 255), then press #.
The opener light will blink once when the temporary PIN has
been learned.
Test by pressing the four buttons for the temporary PIN, then
press Enter. The door should move. If the temporary PIN was set
to a certain number of openings, remember that the test has used
up one opening.To clear the temporary password, repeat steps
1-3, setting the number of hours or times to 0 in step 3.
One ButtonC/ose:Openercan be closed by pressing only the ENTERbutton if the one button close feature has been activated. This
feature has been activated at the factory. To activate or deactivate this feature press and hold buttons 1 and 9 for 10 seconds. The keypad
will blink twice when the one button close is active. The keypad will blink four times when one button close is deactivated.
36

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido