Work Pro WNC 1 Guía Rápida página 9

WNC 1 (AS BLUELINE DIGITAL LOCAL CONTROL)
WNC 1 can also be used as local control in BluLine Digital installation.
Using the same WorkCAD software, it is possible to associate to one receiver device inside BlueLine Digital
series (BLR 2, BLR Lite or BLR 2A) on a common LAN and control two basic parameters such as input source
selection and output gain.
Through WORKCAD software, you can configure a WNC 1 to a specific output and control remotelly these two
magnitudes.
The process of associating a WNC 1 to a specific device is very fast and intuitive through this software, being
able to reassign the device at any time.
1. Check the network in order to find both devices: the wallmount controller (WNC 1), and the BlueLine
receiver (BLR-2 Lite in this case).
2. Once selected in the project, both devices will appears in the upper side with a green dot (both devices
are connected to the same LAN).
3. Press the WNC 1 device in PROJECT INSPECTOR section. The software will ahow the following window.
Quick Guide
ANNEX I
EN
WNC 1