Sartorius YDO01SW-232 Instrucciones De Instalación página 7

Installing the Profibus Controller
§ Fasten the RS-232 interface (including the connector board) into the applicable opening
on the new rear wall panel (below): fasten the 2 screws in the connector mounting.
§ Attach the ribbon cable: insert the ribbon cable for Profibus connection into the
applicable slot on the digital board (on the left in the illustration).
$ Where applicable, insert the ribbon cable for the RS-232 interface into the applicable slot
on the digital board (on the right in the illustration).
§ Connect the cable
– Attach the 4 conductors to the terminal in accordance with their color-coding.
– Plug the connector on the cable into the socket on the right.
§ Insert the ribbon cable for Profibus connection into the applicable slot on the interface
module (YDO01SW-DP).
$ Where applicable, insert the ribbon cable for the RS-232 interface into the applicable slot
on the connector board (on the left in the illustration).
§ Fasten the rear wall panel to the Signum scale: fasten the 6 screws.
Configuring the Profibus interface for operation
After installing the interface module into the scale and configuring it, configure
the Profibus interface for its intended function with the aid of the operating menu.
For more information, please refer to the chapter entitled "Configuring the Modules."
The Signum operating manual chapter entitled "Configuration" contains additional details
7