Handshaking Connections - GE PACE1000 Instrucciones De Seguridad Y Guía Del Usuario

Instrument
Instrument Connector
Function
RxD (I/P)
TxD (O/P)
GND
CTS (I/P)
RTS (O/P)
Pulled
high
internally
Not
connected
Pulled
high
internally
Equipment Connector
chassis

6.2 Handshaking connections

Software handshaking use: TXD, RXD and GND.
Hardware handshaking use: TXD, RXD, GND, CTS, RTS and DTR.
6.3 IEEE 488 Interface
The interface complies with IEEE 488 standard.
The IEEE 488 parallel interface connects a computer/controller to one or more PACE1000
instruments and other instruments.
Up to 30 instruments can be connected through a high-speed data bus to the computer/
controller.
Note: The length of each IEEE 488 cable must be less than 3 metres to comply with the EMC
requirements (Ref: Data sheet).
6.4 Single Unit Installation (Figure 8)
1. Connect an IEEE 488 connector/cable assembly to the rear panel of the instrument.
2. Connect the other end of the connector/cable assembly to the IEEE 488 connector on
the controller/computer.
3. Change the IEEE 488 communication parameters (Ref: K0470, User manual, Supervisor
set-up, section 6.7).
[EN] English
Signal
9-way Direction
D-type
Pin No.
3

2 
5

7

8

1

4

6


shell
Table 1 RS232 Connections
Control Line
RS232
Terminology
TxD
RxD
GND
RTS
CTS
RLSD
(DCD)
DTR
DSR
DCE Ready
Cable Screen
14
Computer/Printer
Connector Type
9-way 25-way
D-type D-type
Pin No. Pin No.
3 2
2 3
5 7
7 4
8 5
1 8
4 20
6 6
- 1
K0467 Revision A