Grease Trays, Filters And Spacers; Heat Lamp Installation - Thermador PROFESSIONAL Serie Manual De Instrucciones

Installing Grease Trays, Filters
and Spacers
4
1 – Filter Spacer
2 – Filter
3 – Grease Tray
4 – Grease Tray Trough
1. Remove all plastic from hood pieces.
2. Insert in the following order:
1) Grease Tray — Push up and in over the rear lip.
2) Filters — Slide filter over the front lip. Push filter
rear up, then slide back over rear lip (Figure 32).
Installation Instructions
1
2
3
Figure 30: Hood and Parts
Figure 31: Grease Tray
3
3) Filter Spacer — Insert these the same way as the
filters.
3. Reverse the above directions to remove the grease
tray, filters and filter spacer.
NOTE: Do not use cooktop while hood is disassembled.
Grease trays must be in place before installing the filters.

Heat Lamp Installation

• Turn heat lamp clockwise to install (Figure 33).
• Replace lamp with either a PAR-38 175W heat lamp or
a PAR-40 250W heat lamp.
Refer to the Use and Care Guide for additional information.
Figure 33: Heat Lamp Replacement
2
1
Figure 32: Filters
English | 20 |