Preventive Maintenance - Astralpool CANCUN Serie Manual Técnico. Puesta En Marcha Y Funcionamiento

15. PREVENTIVE MAINTENANCE

A record should be kept of each element repaired or substituted as well as of all
maintenance and repairs.
The surface of the exterior panels may be cleaned with a soft cloth and non-abrasive
cleaner.
DISCONNECT THE EQUIPMENT FROM THE POWER SUPPLY before performing
any maintenance procedures.
Evaporation unit:
The units should be kept clean and free of obstacles which may hinder the circulation of air
through them. In order to clean them, use water (no pressure) and non-abrasive detergents or
cleaning liquids made specifically for them (consult the manufacturer).
Compressor:
Verify that the compressor refrigerates adequately with the circulating gas (verify the
refrigerant charge. Section 19).
Verify that the power consumption has not increased.
Verify that the compressor discharge pressure is not too high and that the intake pressure is
not too low.
Verify that the compressor fasteners are not deteriorated.
Verify that no frost develops on the compressor.
Condenser:
Install the chemical doser ain the exit of the heating pump, as far as possible and under the
exit level.
Do not set concentrated chemical products in the skimmers that could attack the Titanium
include in the condenser.
In cold weathers where froze is usual, it is necessary to purge all the cleaning and heating
elements. In order to do that, the condenser includes a plug to purge it.
Fan:
Verify the flows of the fan each year.
Clean the louvers of the fan as well as the protection grill regularly.
Electrical panel:
Verify all electrical connections.
Verify that there is no over-heating of the electrical terminals.
Verify that the protection systems operate correctly.
Verify that the regulator operates correctly and verify the temperature with a mercury
thermometer (calibration probe).
WARNING: in the case that the equipment will be shutdown for a long period of
time, we recommend you remove the equipment or periodically ventilate the area where the
equipment is located. This is because the humid and often corrosive (chlorinated) areas
where the equipment is located may lead to premature deterioration of the electrical
components. The warranty does not cover damage due to prolonged exposure to humid and
corrosive atmospheres.
ENGLISH
52