Cleaning The Fuel Filter Pot; Engine Oil; Checking Level And Adding Engine Oil - KUBOTA Z482-E3 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

14
PERIODIC SERVICE
BCleaning the fuel filter pot
Every 100 hours of operation, clean the fuel filter in a
clean place to prevent dust intrusion.
1. Close the fuel filter lever.
(1) Fuel filter lever
(2) Fuel filter pot
2. Remove the top cap, and rinse the inside with diesel
fuel.
3. Take out the element, and rinse it with diesel fuel.
4. After cleaning, reinstall the fuel filter, keeping out of
dust and dirt.
5. Air-bleed the injection pump.
A Entrance of dust and dirt can cause a malfunction of
the fuel injection pump and the injection nozzle. Wash
the fuel filter cup periodically.
(1) O ring
(2) Filter element
(3) Spring
(4) Filter bowl
(5) Screw ring
(A) "OFF"
(B) "ON"

ENGINE OIL

To avoid personal injury:
A Be sure to stop the engine before
checking and changing the engine
oil and the oil filter cartridge.
A Do not touch muffler or exhaust
pipes while they are hot; Severe
burns could result. Always stop the
engine and allow it to cool before
conducting
maintenance, or for a cleaning
procedure.
A Contact with engine oil can damage
your skin. Put on gloves when using
engine oil. If you come in contact
with
engine
immediately.
A Be sure to inspect the engine, locating it on a
horizontal place. If placed on gradients accurately, oil
quantity may not be measured.
A Be sure to keep the oil level between upper and lower
limits of the oil gauge. Too much oil may cause a drop
in output or excessive blow-by gas. On the closed
breather type engine in which mist is sucked through
port, too much oil may cause oil hammer. While too
little oil, may seize the engine's rotating and sliding
parts. (The closed breather is an option.)
BChecking level and adding engine oil
1. Check the engine oil level before starting or more than
5 minutes after stopping the engine.
2. Remove the oil level gauge, wipe it clean and reinstall
it.
3. Take the oil level gauge out again, and check the oil
level.
(1) Oil filler plug
[Lower end of oil level gauge]
(2) Oil level gauge
(A):Engine oil level within this
inspections,
oil,
wash
it
off
range is proper.

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Z602-e3D722-e3D782-e3D902-e3

Tabla de contenido