Installing The Canopy Housing; Installing The Light Kit Assembly - Fanimation The Celano Manual Del Propietário

NOTE: This step is applicable after the necessary wiring
is completed.
▲WARNING
To avoid possible fire or shock, make sure that the
spliced electrical wires are turned upward and completely
pushed carefully up into the junction box and not pinched
between the housing and the ceiling.
1. Remove one of the two shoulder screws in the hanger
bracket. Loosen the second shoulder screw without fully
removing it. Assemble canopy by rotating key slot in
canopy over shoulder screw in hanger bracket. Tighten
shoulder screw. Fully assemble and tighten second
shoulder screw that was previously removed. (Fig.1a)
CAUTION
To avoid possible electrical shock, be sure electricity is
turned off before installing downlight assembly.
1. Loosen three screws and remove one screw from
support flange. (Figure 1).
2. Securely attach the Adapter Plate to the Support bracket
and tightening three screws. (Figure 2)
3. Securely attach plugs from motor to sockets on Downlight
Support Plate Assembly (Figure 3)

Installing the Canopy Housing

Installing the Light Kit Assembly

Figure 1a
2.
Securely attach and tighten the Canopy Screw Cover
over the shoulder screws in the Hanger Bracket utilizing
the keyslot twist-lock feature (Figure 1b).
9
Figure 1b
Figure 1
Figure 2
Figure 3