Laundry Method With Intermediate Spin; Cleaning After Use - Danby DTT100A1WDB Manual De Instructions Pare El Uso Y El Cuidado De Su Unidad

You can improve the rinsing effect and save
rinsing water by using an intermediate spin
between wash and rinse process:
1. WASH
• Operate the wash process as described in
wash procedure
2. Drain
• Drain the wash-tub by turning the drain valve
selection switch to DRAIN position
3. Intermediate Spin
• Move the laundry to the spin-tub
• Operate the spin process for about three
minutes as described in the spin procedure
4. Rinse
• Move the laundry to the wash-tub
• Operate the rinse process for about two to
three minutes
Cleaning after use will extend the life of your
washing machine. Before cleaning, shut off the
power switch and disconnect the power cord
from the electrical outlet, being sure to take
hold of the plug.
Cleaning the body
• Wipe with a soft cloth
• If extremely dirty, wipe with a cloth soaked in
a solution of water and dish detergent or
soap.
• Do not spray the washing machine with water
or use paint thinner, abrasive cleanser,
benzene, alcohol, etc., to clean it.
Cleaning the lint filter
• Turn the filter
• Remove the
inside out and
filter frame by
wash the lint
pulling it
off with water
upward

LAUNDRY METHOD WITH INTERMEDIATE SPIN

CLEANING AFTER USE

• Insert the
filter frame
into the center
agitator as it
was
5. Intermediate spin
• Move the laundry to the spin-tub
• Operate the spin process for about three
minutes as described in the spin procedure
6. Overflow Rinse
• Move the laundry to the wash-tub
• Open the water tap
• Operate the rinse process for about two to
three minutes continuing water supply
7. Final spin
• Move the laundry to the spin-tub
• Operate the spin process
Cleaning the overflow strainer
• Remove • Wash off
the strainer the lint
by pulling it stuck in the
forward strainer
during
overflow
Cleaning the drain strainer
10
• Re-install
the strainer
1) Remove the drain
strainer from the bottom
of the tub using a sharp
tool such as a screw
driver
2) Wash off the lint stuck
in the strainer
3) Re-install the strainer