Installing Your Canopy Housing; How To Assemble Your Light Kit Assembly Or Cap - Fanimation Subtle FPD6236 Serie Manual Del Propietário

NOTE: This step is applicable after the neccessary wiring
is completed.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)

How to Assemble Your Light Kit Assembly or Cap

1. Remove one of the three screws in the adaptor
plate at the bottom of the motor assembly. Slightly
loosen the remaining two screws. Assemble the light
plate assembly to the adaptor plate of the motor
assembly using the two key slots in the light plate
assembly. Replace the third screw and secure all
three screws. (Figure 1)
2. Remove one of the three screws in the light plate
assembly and retain the screw for Step 4. Slightly
loosen the remaining two screws. (Figure 2)

Installing Your Canopy Housing

WARNING
Light Plate
Assembly
Light Plate
Assembly
12
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
Figure 1
Figure 2
Motor
Assembly