Kohler K-1188-C1 Manual De Instrucciones página 6

Your Overflowing Bath
Your Kohler overflowing bath represents a renaissance in hydrotherapy pleasure unlike anything you have
experienced before. The overflowing bath will transform your bathroom or home spa into a place of
tranquility, rejuvenation, and gracious living you will enjoy for years to come. The overflowing bath will
elevate the spirit-enhancing ambiance of total body immersion, cascading water, and gentle water movement
into your bathroom or home spa. The warm, soothing flow of water and the gentle effervescent bubble action
combine with the enrapturing walls of cascading water to create a relaxing retreat from the cares and worries
of your day.
If you are like most people who install a Kohler overflowing bath, you cannot wait to get in and try it out.
You will soon find that the features and controls are very simple to use, offering a safe and totally relaxing
personal care experience. Please spend a few minutes reading these operating instructions, then you will be
ready to go.
Overflowing Bath Operation
Remove all loose bathing items (such as soap bars, shampoo bottles, and washcloths) from inside
the unit.
NOTE: Do not use excessive amounts of shampoo or soap while you are operating the overflowing bath.
Of course, you can freely use shampoo and soap for showering before you fill the unit.
Make sure the metal suction screen is clean and placed correctly over the plastic suction cover.
Close the drain.
NOTE: The water temperature in the bath should not exceed 104°F (40°C). The in-line heater will
automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the
water cools.
NOTE: The in-line heater will help maintain the water temperature while your overflowing bath is
running. Always fill the unit with water tempered to your desired comfort level.
Fill the unit with water to a level where the overflow channel sensors are completely covered and
the water in the bathing well runs into the overflow channel drain.
Within 1/2 minute after the overflow channel sensors are submerged, the green light on the pump
control switch will automatically start to blink. This indicates the pump/motor is ready to begin
operation.
Fill the unit 4" (10.2 cm) to 6" (15.2 cm) above the bathing well rim.
NOTE: Like any other bath, prevent flooding the area around the unit by entering the filled bathing well
slowly. This will allow the system to properly drain excess water.
1019731-5-D
Overflow
Channel Drain
Overflow
Channel
Sensors
Water
Pump Control
Switch
6 Kohler Co.