Downloading Results To A Pc - Megger OTS 60AF Guia Del Usuario

Operation
To transfer test results to a PC, connect a suitable cable (see below) between the RS232 socket on the
OTS and a serial port on the PC. A suitable communications program is required on the PC.
When the OTS is set to print to an external printer, text will appear on the PC display, which may be
copied to other programs for storage or calculation.
RS232 Cable
The following shows the cable connections which has been found to work with Microsoft
Hyperterminal programs:-
PC: 'D' type socket
Function 25 Pin
RXD (i/p) 3
GND 7
RTS (o/p) 4
DCD (i/p) 8
DTR (o/p) 20
DSR (i/p) 6
Shell
Configuring the OTS
From the main menu, choose OPTIONS and then PRINTER CONTROL. Verify the following settings:-
It may be useful to set AUTOPRINT to On, which will cause the OTS to output data automatically after
each test sequence.
Refer to page13 'Setting the Printer options' for further information on how to do this.
Configuring the PC Communication Program
The following settings have been found to work with Microsoft
28

Downloading Results to a PC

9 Pin
2
5
7
1
4 Joined together
6
Braid
(Screen)
Baud Rate -
Ext. Printer -
Baud Rate -
Data Bits -
Parity -
Stop Bits -
Flow Control -
OTSAF/2 9 pin 'D' type socket
Pin
3
5
6
1, 7, 8 Not connected.
2, 4, 9 Reserved - Do not connect.
Shell
9600
ON
® Terminal and Hyperterminal programs.
9600
8
None
1
Hardware
® Terminal and
Function
TXD (o/p)
GND
Busy (i/p)