Tabla De Contenido; Introduction; Accessories; Installation - Carrier 80HMA-9002 Manual De Instalación

Contents
Introduction ...................................................................................1
Accessories ..........................................................................1
Installation .......................................................................................1
Application schema ..........................................................1
Configure the system - Variable Table ..........................2
Configure the system -
Input and output configuration ....................................5
Wiring Connection Diagram ...........................................6
Installation recommendation ........................................7
Feature ...........................................................................................8

Introduction

The Pool Kit combined with the Comfort Module or
Control box, is the control board that permits the
managing of the heating/cooling system for a swimming
pool, driving all the needed devices.

Accessories

Code
33AW-CS3
80AW9023

Installation

Application schema

Pic. 3 and pic. 4 show a possible schema to connect the Pool
Kit to the hydraulic circuit and the required devices.
All the input and output are fully customizable, so these
pictures are only for illustrative purpose.
Pic. 4 shows a possible installation with most of the devices
available; however it's possible to use less sensors or
actuators. This manual explains what is the behavior of the
Pool Kit with or without these devices.
Pic. 3: Hydraulic Circuit
1. Heat pump
2. Comfort Module
3. Sanitary water tank
4. Manometers
5. Ball valves
6. Water filter
7. Three way valve for sanitary tank
8. Pool heat exchanger
9. Auto purge air valve (put in the highest positions in the
hydraulic circuit)
10. Three way valve for pool heat exchanger
11. Filling system valve
12. To room terminals
13. To pool system
1
80HMA - 9002
Devices connectable ....................................................................8
Controller Operation ................................................................. 10
Diagnostic ..................................................................................... 10
All the devices (valve, pump, pipes,...) are field supplied and
should be dimensioned according to the size and power
requested for the system.
Description
User Interface
3.way valve and actuator
Pic. 4: Pool System
1. Pool kit 80HMA-9001
2. Pool User Interface
3. Swimming pool
4. Three way valve for pool heat exchanger (80AW9023 in
5. Pool heat exchanger
6. Flow switch
7. Water to exchanger temperature sensor
8. Pool water temperature sensor
9. Leaving water to pool temperature sensors
10. Cleaning pool system
11. Pool pump
12. Mixing valve
13. Hydraulic circuit from heat production
14. Hydraulic circuit to the system
NOTE: Pool Kit can be matched with Comfort Module
(80HMA) or Control Box (32HMA).
Water Pump (ref. 11 on pic. 4) .........................................8
Proportional Valve (ref. 12 on pic. 4) .............................8
Flow Switch (ref. 6 on pic. 4) ............................................9
Three way valve (ref. 4 on pic. 4) ....................................9
Water Pool temperature sensor
(ref. 8 of pic. 4) .....................................................................9
Leaving Water to pool temperature sensor
(ref. 9 of pic. 4) .....................................................................9
Water to heat exchanger temperature sensor
(ref. 7 of pic. 4) .....................................................................9
Pressure Switch ..................................................................9
Notes
Additional user interface
To drive the water to the pool heat exchanger
this example)
Power Supply for Pool Board (1=L, 2=N)
To CCN Network
Black
Brown
Blue
Open
Close
Pool Kit