Festo CMXR-C2 Manual De Instrucciones página 14

Warning
S Switch off the power supply before connecting or
disconnecting plug connectors (otherwise functional
damage).
S Use only power sources which guarantee reliable
electrical isolation of the operating voltage as per
IEC/EN 60204−1. Observe also the general
requirements for PELV power circuits as per
IEC/EN 60204−1.
S Connect an earth conductor of sufficient cable cross
section to the connection on the CMXR−C2 terminal
marked with the earth symbol.
S The CMXR−C2 contains electrostatically sensitive
components. Therefore, do not touch any
components. Observe the handling specifications for
electrostatically sensitive devices.
For commissioning with FCT you will need the following
software packages:
1. FCT − Festo Configuration Tool for CMXR−C2
2. CoDeSys provided by Festo
3. TSP for Motion Controller CMXR−C2
You can download these software packages from the In
ternet at www.festo.com
14 Festo GDSP−CMXR−C2−SY−ML 1008a English