Crouzet CTR48 Manual Del Usuario página 30

Quadrature input*
INP A: count input 0°
INP B: count input 90°
Quadrature with pulse dou-
bling*
INP A: count input 0°
INP B: count input 90°
Each pulse edge of INP A will
be counted
Quadrature x4 *
INP A: count input 0°
INP B: count input 90°
Each pulse edge of INP A and
INP B will be counted.
* does not apply to the output operation
Multifunction totalizer
6.8.3.3 Main menu for configuration
Main menu for matching the
input pulses and display
Multiplication factor
Multiplication factor can be
programmed from 00.0001 to
99.9999. The setting 00.0000
will not be accepted
Division factor
Division factor can be pro-
grammed from 01.0000 to
99.9999. The setting <01.0000
will not be accepted
Decimal point setting
Decimal point (only display
function)
0
0.0
0.00
0.000
0.0000
0.00000
9
no decimal place
1 decimal place
2 decimal places
3 decimal places
4 decimal places
5 decimal places
Display colour
(only for red-green version)
Display colour
upper line
lower line
Display colour
upper line
lower line
6.8.3.4 Main menu for reset mode
See below 6.8.6
6.8.3.5 Preset 1
See below 6.8.7
6.8.3.6 Preset 2
See below 6.8.8
6.8.3.7 Main menu Programming lock
See below 6.8.9
6.8.4 Timer
6.8.4.1 Main menu for output operations
For counters with 1 preset,
output 1 is the main preset, so
the text relating to output 2 ap-
plies to this preset for the de-
scription of the output
operations. For the batch
counter and totalizer functions,
in case of counters with 1 pre-
set, the batch counter and the
totalizer are only for display
purposes. For counters with 2
presets, the main preset al-
ways = output 2. Output 1 =
pre-signal, For the batch
counter and totalizer functions,
these act on preset 1.
In case of subtracting output
operations, a Reset sets the
counter to a new preset value
Main menu for determining the
output operations
red
red
red
green