Kenmore 911.95281 Manual De Uso página 3

®
SAVETHESE RNSTRuc'rRo ,J$
Read all instructions before using this appliance. When using gas or
electrical appliances, basic safety precautions should be followed,
including the following:
o All Ranges Can Tip ;i._:i
o Injury To Persons ,
Could Result
:::_::i
Device Packed
o See Installation
Instructions ....
Adjacent cabinet
or final
location
of range
side
panel
Tools you will need:
o Phillips head screwdriver
o 13/8 " open end or adjustable
wrench
1. Remove the bracket from the
prepack located inside the oven.
2. Decide whether the bracket will be
installed on the right or left side of
range location.
3. If the bracket side of the range is
adjacent to a cabinet, place the
bracket against back wail and
cabinet as shown in Figure 1.
If there is no adjacent cabinet,
determine where the location of
the range side (painted outside
panel) will be. Place the bracket
with its outside edge at this
location and against back wall.
See Figure 2.
4. Determine whether you will anchor
the bracket to the floor or wall.
Make sure this location is clear of
electrical wiring or plumbing.
Outside edge of
bracket to be flush with
left or right of range
Fig, 1
=
Fasten the bracket securely with
the screws provided. Screws are
self-drilling in wood, plywood,
particle and chip board, and most
metal framing. If attaching to
masonry, you can buy suitable
screws and anchors at hardware
stores. Use a masonry drill bit to
drill the required holes.
Br c.e,\ ti
Screw must enter _Ji!l
wood o rmetal.,...__ fji::l
Fig, 2
Wall plate
/
Attachment to walt
6_
=
Using the wrench, back out the
four leg levelers at least two turns.
See your installation guide for
more leveling information before
positioning range.
Slide the range into place. Be sure
rear leg leveler fully engages the
slot in the bracket. If range cannot
be moved back far enough for
rear leg leveler to enter bracket,
move bracket forward as required
and attach to floor in new location.
3