Pentair Water Pool and Spa SAm Manual Del Propietário página 7

Be sure the power is OFF before installing or removing lamp. Allow the lamp to cool before relamping. This light fixture uses
a quartz Halogen lamp. DO NOT touch the lamp with bare hands: This may severely reduce its life. Use the plastic furnished
with the replacement, a clean rag, or a tissue to eliminate fingerprints from getting on the lamp.
5. Install the new lamp(s).
a. Push bulbs into white socket.
b. Squeeze copper bulb retainer and slide bulb in from side.
c. Ensure bulb is tight against copper plate between locating guide bumps.
6. Remove old gasket from lens and discard it.
7. Swing color wheel/bulb assembly back into position over 4 fixture studs. Secure with 4 nuts. Do not over
tighten.
8. Install new gasket during reassembly of light, Pentair Water Pool and Spa P/N 79101600.
Never operate the underwater light for more than 10 seconds unless it is totally submerged in water. Without total submersion,
the light assembly will get extremely hot and may result in serious burns or in breakage of the lamp or lens. This may result in
serious injury to pool users, installers, or bystanders, or in damage to property.
9. Align the special pilot screw on the face ring with the letter "O" of the word "TOP" on the surface of the lens.
The pilot screw, "O" in "TOP" and the white pointer on the color wheel/bulb assembly should also align with
the cord compression fitting on the top rear of the light fixture.
10. Align the special pilot screw on the face ring with the letter "O" of the word "TOP" on the surface of the lens.
The pilot screw, "O" in "TOP" and the white pointer on the color wheel/bulb assembly should also align with
the cord compression fitting on the top rear of the
light fixture.
11. Secure ring to light fixture. See Section VI.,
Stainless Steel Face Ring Assembly Instructions.
12. Replace light assembly into niche and tighten special
pilot screw.
WARNING
Use only the special pilot screw provided with this underwater
light. This screw mounts and electrically grounds the housing
securely to the mounting ring and wet niche. Failure to use the
screw provided could create an electrical hazard which could
result in death or serious injury to pool users, installers or
others due to electrical shock.
13. Fill pool until the underwater light is completely
submerged in water before operating the light for
more than 10 seconds. Turn on main switch or
circuit breaker, as well as the switch which operates
the underwater light itself, to check for proper
operation. Refer to Operating Instructions, Section
IV., for full function test.
Rev. B • Rev. B • Rév. B 10-29-07
WARNING
WARNING
7
Copper Lamp Retainer
Bulbs (2)
Figure 3.
P/N • Núm/Pte. • Réf. P/N 619587